Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
15.3.3 Slot cuts
Set the depth stop for slot cuts so that the desired cutting depth is obtained at the selected angle.
Make the mitre or sliding cuts as described in the respective chapter with the difference that the
workpiece is not completely cut through.
16
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage! Handling at the machine with upright
power supply can lead to serious injuries or death. Always disconnect the
machine from the power supply before cleaning, servicing or maintenance work
and secure it against unintentional reconnection!
16.1 Cleaning
Wrong cleaning agents can attack the varnish of the machine. Do not use
solvents, nitro thinners, or other cleaning agents that could damage the
machine's paint. Observe the information and instructions of the cleaning agent
manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Therefore, clean the machine after each use and remove any sawdust with a brush,
broom or vacuum cleaner.
16.2 Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Before each operation, check that the safety devices are in perfect condition.
Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
Use only proper and suitable tools.
Only use original spare parts recommended by the manufacturer.
16.2.1 Maintenance schedule
The type and degree of machine wear depend on the operating conditions. The following intervals
apply when the machine is used within the specified limits:
interval
Before usage
After usage
after 50h (/ 10h)
When required
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
WARNING
NOTE
components
activity
Saw blade
Check for damage and replace if necessary.
Saw blade guard
Check function (see function check saw blade protection)
Table inlet
Check for damage and replace if necessary.
Cable
Check for damage and repair if necessary.
Maschine
Saw blade guard
Remove dust/wood splinters and dirt
Chip bag
Carbon brush
Check and replace if necessary.
Check sharpness of saw blade and replace when
Saw balde
necessary
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
32
ZI-KGS255DS
Publicidad
Tabla de contenido
