Saw Blade Change; Setting The Laser - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

16.2.3 Saw blade change

Risk of injury! Wear protective gloves when changing the saw blade.
- Swivel the machine head upwards and lock it with the locking bolt (11).
- Insert the Allen key into the flange screw (31) with one hand.
- Firmly press the saw shaft lock (36) and slowly turn the screw (31) clockwise. The saw shaft
lock (36) engages after one turn at the latest.
- Loosen the flange screw (31) clockwise and remove the screw and the outer flange (30).
- Fold the saw blade guard (20) upwards.
- Remove the saw blade (35) from the inner flange and pull it downwards.
- Carefully clean the flange screw (31), outer flange (30) and inner flange.
- Mount and fasten the new saw blade (35) in reverse order.
Pay attention to correct direction of rotation and dimension of the saw blade (6)
Limits for dimension: Max. Diameter of 255mm and max. thickness of 2.8mm,
as well as mounting diameter of 30mm.
- Before continuing with your work, make sure that all safety devices are in good operating
condition. (Saw blade protection check)
- Important! Always when you change the saw blade (6), check that it rotates freely in the table
insert (10) in both cases. Vertical and 45° angle settings.
- Important! The work for changing and aligning the saw blade (6) must be carried out correctly.

16.2.4 Setting the Laser

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
CAUTION
CAUTION
If the laser (17) does not show the correct cutting
line any more, you can adjust the laser. Loosen the
Phillips screws (S) and adjust the laser by moving it
sideways until the laser beam hits the teeth of the
saw blade. Tighten both screws (S) again.
34
ZI-KGS255DS