Adjusting The Angular Position (By Means Of Stop Angle) - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

16.2.2 Adjusting the angular position (by means of stop angle)

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
90°-cut
Lower the machine head and secure it
with the locking bolt (11).
- Loosen the fixing screw (1).
- Position the 90° stop angle (W)
between the saw blade and the rotary
table.
- Loosen the lock nut on the adjusting
screw (25) and adjust the adjusting
screw (25) until the angle between saw
blade and rotary table is 90°.
- Tighten the lock nut again.
- Then check the position of the angle
indicator. If necessary, loosen the
pointer (10) with a Phillips screwdriver
and move it to the 0° position on the
scale (10-1) and then fix it again.
45°-cut
Lower the machine head and secure it
with the locking bolt (11).
- Fix the rotary table in the 0° position.
- Loosen the fixing screw (1) and angle
the machine head with the handle 45° to
the left.
- Position the 45° angle stop between
the saw blade and the turntable.
- Loosen the lock nut on the adjusting
screw (26) and adjust the adjusting
screw (26) until the angle between saw
blade and turntable is exactly 45°.
- Tighten the lock nut again.
- Then check the position of the angle
indicator. If necessary, loosen the
pointer (10) with a Phillips screwdriver,
bring it into position 45° on the angle
scale (10-1) and tighten the fixing screw
again.
33
ZI-KGS255DS