Publicidad
Idiomas disponibles
Idiomas disponibles
[ellJll]illl_lile]:l
1:l)[41l:ll_k'l[I]_:
[ata];llk
[lJli=|ilPl_k_._--"'Jllll].
This cutter is double insulated to protect you from
electrical
shock.
IA WARNING I
Double
insulated
tools am equipped
with a polarized
plug (one blade is wider than the other).
This plug will
f_ into a polarized
outlet
only one way.
If the plug
does
not fit fully into the outlet, reverse
the plug.
If it
still does
not fit, contact
a qualified
etacITIclan
to
install a polarized
outlet.
Do not alter
the plug in any
way.
Double insulation eliminates
the need for the three
wire grounded
power cord and grounded
power supply
system.
Avoid body contact
wlth grounded
surfaces
such as
pipes, radiators,
ranges
and refrlgerators.
There is an
increased
risk of electric shock if your body is grounded.
Do not expose
power
tools to rain or wet conditions.
Water entering a power tool will increase
the risk of
electric shock.
Do not abuse
the cord.
Never
use the cord to carry
the tool or pull the plug from the outteL
Keep cord
away from heat, oil, sharp edges
and moving
parts.
Replace
damaged
cords
immediately.
Damaged
cords
increase the risk of electhc shook.
When
operaUng
a power
tool outdoors,
use an
outdoor
exteesfon
cord marked
"W-A"
or"W".
These
cords are rated for outdoor use and reduce the risk of
electric shock.
IA,
WARNING
I
Always
make sure the receptacle
Is polarized.
If you
are not sure, have a qualified
electllclsn
check
the
receptacle.
Make sure your extension
cord
is in good condWon.
When
using an extension cord, be sure to use one heavy
enough to carry the current the tool will draw. An
undersized
cord will cause a drop in line voltage resulting
in loss of power told overheating.
The table below shows
the correct size to use according to cord length and
nameplate
ampere rating. If in doubt, use the next heavier
gauge.
The smager the gauge
number the heavier the
cord.
Be sure your extension
conS is properly
wired and in
good condition, Always replace a damaged
extension
cord or have it repaked by a qualified electrician
before
using it. Proteet your extension cord from sharp objects,
excessive
heat and damp or wet areas.
Use a separate
electrical
circuit for your power
tools.
This circuit must not be less than 14 gauge wire and
should be protected with either a 15 Ampere
time delay
fuse or circuit breaker.
Before connecting
the power tool
to the power source, make sure the switch is in the OFF
position and the power source is the same as indicated on
the nameplate.
Running at lower voltage will damage the
motor.
IA WARNINOI
Repair or rspla¢l)
damaged
or worn extension
cords
immediately.
Select the appropriate
extension cord gauge and length
using the chart below.
MINIMUM
GAUGE
(AWG)
EXTENSION
CORDS
(120 Volt use only)
Ampere
Rating
Total length in feet
Not
More Than
More Than
25'
50'
100'
150'
0
6
18
16
16
14
0
10
18
16
14
12
12
16
16
14
12
12
16
14
12
NOt Applicable
_A WARNING I
Keep the extm_
cord clear of the working
area.
Position
the coRl so It will not get caught
on the
workptace,
too_
or any other obstructions
while you
are working
w#h the power
tool.
Publicidad
