Publicidad
Threading
the Machine
• Threading
the machine
*Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise,
toward you.
*Raise the presser foot lifter.
*Place a spool on the spool pin, with thread coming off as
shown.
[]
Draw the end of thread around the upper needle thread
guide.
[]
While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[]
Firmly draw the thread up from right to left over the
take-up lever and down into the take-up lever eye.
[]
Slide the thread behind the needle bar thread guide on
the left.
[]
Thread the needle from front to back or use a needle
threader.
We recommend using the convenient needle threader
(#200262101).
S
• Drawing
up bobbin thread
[]
Raise the presser foot. Hold the needle thread lightly
with your left hand and rotate the handwheel
counterclockwise,
toward you, for one complete turn.
[]
Bring the bobbin thread up by pulling the needle thread
up.
[]
Pull both threads under and to the back of the presser
foot, leaving 4 to 6 inches (10 cm to 15 cm) of thread
clear.
S
[]
[]
[]
J
28
Publicidad
