Craftsman 247.770990 Manual Del Operador página 6

Bottle of
Engine Oil
Fresh Start
TM
Cartridge
@
Safety Glasses
Assembly
Drive
Control
Rope
Guide
Up!er
Handle
Bracket
Upper
Handle
Speed
Control
Lower
Handle
Handle
Knobs
BIo
Chute
Cable
Guide
Lower j
Hose
Handle
Bracket
Screws
Wing
Nuts
Figure 1
IMPORTANT:This unit is shipped without gasoline or
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.
NOTE:
Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses, the owner's manual, a bot-
tle of engine oil, and one FreshStart
TM
cartridge are
also included in the carton. See Figure 1.
OPENING CARTON
• Cut each corner of the carton vertically from top
to bottom.
• Remove all loose parts.
• Remove loose packing material.
REMOVING UNITFROM CARTON
• Lift unit from the rear to detach it from underlying
carton material and roll unit out of carton.
• Check carton thoroughly for any other loose
parts.
NOTE:
Make sure not to crimp cables while
removing loose parts or the entire unit from the
carton.
LOOSE PARTS IN CARTON
(SeeFigurel)
• Upper and Lower Handle
• Hose Assembly
• Bag
• Blower Chute
• Safety Glasses
• A Bottle of Engine Oil (may be located in bag)
• Operator's Manual
• FreshStart
TM
Cartridge
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground it onto the retaining post on
the engine. This will prevent accidental starting of
the engine. See Figure 2.
Retaining Spark
PlugWire
0 ©
Disconnect and Ground to
Figure 2