Bosch Truvo Manual Original página 25

– Switch the measuring tool on and off again within 3 s using the on/off
switch (2). The light-up ring (5) will flash red slowly for the 3 s to indicate
readiness for calibration.
– Switch the measuring tool back on within 0.5 s. The calibration will start
and take roughly 6 s. During calibration, the light-up ring (5) flashes
green quickly. Once the light-up ring (5) lights up green continuously, the
calibration is complete and the measuring tool is ready to use.
Note: If the sequence of switching off and switching on again is not ob-
served, calibration will not take place. The light-up ring (5) continues to light
up yellow or red even though there is no metal nearby. In this case, repeat
the calibration in the exact same way.
Errors – Causes and Corrective Measures
Cause
Measuring results inaccurate/implausible
Interfering objects are
within the sensor
range (8)
Auto-calibration not suc-
cessful
Light-up ring does not light up.
Measuring tool has
switched off automatic-
ally.
Batteries drained
Light-up ring lights up green/yellow/red in an uncoordinated manner.
Interference from elec-
tric, magnetic or electro-
magnetic fields
Light-up ring flashes continuously, alternating green/yellow/red.
Measuring tool faulty
Bosch Power Tools
Corrective measures
Remove all interfering objects (e.g. watches,
bracelets, rings, etc.) from within range of the
sensor (8). Do not hold the measuring tool close
to the sensor.
Manually recalibrate the measuring tool.
Switch the measuring tool off and on again.
Change the batteries.
If possible, deactivate all tools whose radiation
could interfere with the measurement and
switch off the corresponding functions or tools.
Send the measuring tool to an authorised Bosch
after-sales service centre.
English | 25
1 609 92A 8B4 | (02.03.2023)