Magmaweld monoCUT 45ix Manual Del Usuario página 24

24 Operation
EN
3.2 Torch Usage
Press the torch trigger by pushing the protective cap on the torch trigger forward when cutting process
is to be started. Plasma arc will occur as soon as you press the torch trigger. The torch tip must be pushed
forward slowly through the material to be cut in order to ensure smooth cutting. When the automation torch is
connected, the machine detects the automation torch and waits for a trigger from the automation interface. It
sends the necessary data to the automation interface. See 5.1 for detailed information on torches.
The torch trigger is active when the power supply is on. Make sure that your hand is not in the
way of the cutting path.
Do not hold the work piece in your hand or point the torch to yourself or anyone else.
USER MANUAL
Adjustment Pot
To adjust the current, the adjustment pot is turned left or right to set the current value
: Current Adjustment /
to certain tolerance ranges.
Press the adjustment pot once to switch to gas adjustment. The machine switches to
free gas mode, the adjusted value is read from the gas pressure adjustment pot. When
you pull the gas pressure adjustment pot on the air filter to the top and set it to the
free position, you can increase / decrease the pressure by turning it to the right / left.
It shows the pressure inside the torch.
Pressure Indicator
Gas Adjustment
monoCUT 45ix / monoCUT 45i
www.magmaweld.com