Delivery Contents; About This Product - Aventics NL1 Instrucciones De Servicio

AVENTICS | NL1 / NL2 / NL4 / NL6 | R412015553–BAL–001–AC | English
W
The warranty will not apply if the product is incorrectly
assembled.
W
Do not place any improper mechanical loads on the
product under any circumstances.
W
Product warnings and information must be legible, i.e.
not covered by paint, etc.
Safety instructions related to the product and technology
W
Lay cables and lines so that they cannot be damaged
and no one can trip over them.
W
Do not operate the product in aggressive ambient air
(i.e. solvent gases).
3

Delivery Contents

The delivery contains:
W
1 distributor as per order
W
Operating instructions
4

About This Product

Distributors are components of maintenance units and are
used to distribute compressed air. Pressure switches can
also be mounted with flange and pipe connections. The
following versions are available:
W
DIS: standard distributor, for pressure switch with pipe
connection
W
DIL: narrow distributor, for pressure switch with pipe
and flange connection
(only pipe connection for NL1)
W
DIC: distributor with center infeed
W
DIN: distributor with non-return valve, for pressure
switch with pipe connection
The following table shows the assignments to the series:
Series Version Distributor
NL1 DIL
DIN
NL2 DIS
DIL
DIC
DIN
NL4 DIS
DIL
DIC
DIN
NL6 DIL
Flow direction from left (IN,
compressed air supply from right
must be rotated 180° along the vertical axis.
5 Assembly, Commissioning,
Operation
O Let the product acclimatize for several hours before
commissioning,
otherwise water may condense in the housing
Danger of injury if assembled under pressure or
voltage!
Assembling when under pressure or electrical voltage
can lead to injuries and damage to the product or
system components.
O Make sure that the relevant system part is not under
voltage or pressure before you assemble the
product.
O Protect the system against being switched on.
System is operating under pressure.
Incorrect installation could damage the maintenance
unit/device and cause serious injury.
O Before start-up, check that all connections, ports,
and maintenance devices have been correctly
installed.
Switch symbols
see
1
2x I
1x IV
4x III
4x III
2x VI
4x V
4x III
4x III
2x VI
4x V
3x II
) to right (2,
, components
2
CAUTION
5
). For