Smeg BLF03PGEU Manual De Uso página 26

Problem
The motor will not start.
The blender vibrates.
The blender switches on,
but the blades do not
turn.
The blender stops while
operating.
The red LED flashes at
regular intervals.
The blender stops during
operation and the white
LED flashes.
If the problem has not been resolved or in the event of another type of fault,
contact your local technical support centre.
26
What to do if...
Cause
The motor has overheated.
The plug is not properly
inserted in the power
socket.
The cable is defective.
Lack of power.
The blender is not resting
on a stable surface.
The anti-slip rubber feet are
worn.
The speed used is too high
or the load is excessive.
The jug has not been
correctly locked into its
base.
The motor has overheated.
The jug is not correctly
inserted in the base.
The blades may have
jammed.
Solution
Unplug the blender and leave
the motor to cool.
Insert the plug into the power
socket. Do not use adaptors
or extensions.
Check that the house main
breaker is on.
Contact an Authorised
Service Centre.
Check that the house main
breaker is on.
Place the blender on a flat,
stable surface.
Have them replaced at an
Authorised Service Centre.
Set a lower speed and ensure
the jug has not been overfilled.
Remove the jug from its base
and lock it into place.
Unplug the blender and allow
the motor to cool down.
Check the position of the jug
on the base.
Unplug and free the blades
using a spatula.