Publicidad
Idiomas disponibles
Idiomas disponibles
• Empty fuel tank before storing the
unit. Use up fuel left in carburetor
by
starting engine and letting it run until
it stops.
• Do not use any accessory or attach-
ment other than those recommended
by manufacturer
for use with your unit.
• Do not store the unit or fuel in a
closed area where fuel vapors can
reach sparks or an open flame from
hot water heaters, electric motors or
switches, furnaces,
etc.
• Store in a dry area out of reach of
children.
SAFETY
NOTICE:
Exposure to vibra-
tions through prolonged use of gasoline
powered hand tools could cause biood
vessel or nerve damage in the fingers,
hands, and joints of people prone to cir-
culation disorders or abnormat swelling.
Prolonged use in cold weather has been
linked to blood vessel damage in other-
wise healthy people. If symptoms occur
such as numbness, pain, loss of
strength, change in skin color or texture,
or toss of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An
antivibration system does not guarantee
the avoidance of these problems. Users
who operate power tools on a continual
and regular basis must monitor closely
their physical condition and the condition
of this tool.
SPECIAL
NOTICE:
For users on U.S.
Forest Land and in some states, includ-
ing California (Public Resources Codes
4442 and 4443), Idaho, Maine, Minne-
sota, New Jersey, Oregon, and Wash-
ington: Certain internal combustion en-
gines operated on forest, brush, and/or
grass covered land in the above areas
are required to be equipped with a spark
arresting screen, maintained in effective
working order, or file engine must be
constructed, equipped, and maintained
for the prevention of fire. Check with
your state or local authorities for regula-
tions pertaining to these requirements.
Failure to foilow these requirements is a
violation of the law. This unit is not facto-
ry equipped with a spark arresting
screen; however, a spark arresting
screen is available as an optional part. If
a spark arresting screen is required in
your area, contact Sears Service for the
correct kit. The spark arresting screen,
blower tubes, and nozzles must be as-
sembled to unit to be in full compliance
with regulations.
CARTON CONTENTS
Check carton contents
against the fol-
lowing list,
Model 358.794961
Blower
Blower tube
Elbow tube
Vacuum bag
Upper vacuum tube
Lower vacuum tube
2-Cycle Engine Oil
NOTE: It is normal for the fuel filter to
rattle in the empty fuel tank.
ASSEMBLY
_WARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum
in-
tet door or attempting
to insert or re-
move the vacuum tubes. The rotating
blades can cause serious injury.
WARNING:
If you receive your
unit assembled,
repeat all steps to en-
--
4
-
sure your unit is properly assembled
and all fasteners
are secure.
•
A standard
screwdriver
is required
for assembly.
BLOWER
ASSEMBLY
BLOWER
TUBE ASSEMBLY
If you have already assembled
your
unit for use as a vacuum,
remove the
vacuum tubes and collection
bag,
1, Align the rib on the blower tube
with the groove in the blower outlet;
slide the tube into place,
NOTE: Knob must be loose enough to
allow biower tube to be inserted in blow-
er outlet. Loosen knob by turning coun-
terclockwise,
Publicidad
