Craftsman 917.376580 Manual Del Usuario página 8

The operationof anylawn
mowercan resultin foreign
objectsthrowninto the
eyes,whichcan resultin
severeeyedamage° Always
wearsafetyglassesor eyeshieldswhile
operatingyour lawnmoweror performing
anyadjustmentsor repairs_ We recom-
menda standardsafetyglassesor wide
vision safetymaskwornoverspectacles°
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
_CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the
risk of blade contact injury. Do not under
any circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
o Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower_
DRIVE CONTROL
• Self-propelling is controlled by hold-
ing the operator presence control bar
down to the handle and pulling the drive
control lever rearward to the handle.
The farther toward the handle the lever
is pulled, the faster the unit will travel.
• Forward motion will stop when either
the operator presence control bar or
drive control lever are release& To stop
forward motion without stopping engine,
release the drive control lever only. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
NOTE: if after releasing the drive control
the mower will not roll backwards, push
the mower forward slightly to disengage
drive wheels,
• To keep drive control engaged when
turning corners, push down on the
handle to lift the front wheels off the
ground while turning lawn mower.
_=ratorpresence controt bar
Drive
control
TO lever
Adjustment ENGAGE DRIVE
turnbuckle DRIVE CONTROL
(on underside) CONTROL DISENGAGED
DRIVE CONTROL ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed. There is a turnbuckle on the
underside of the drive control housing to
increase tension on the drive cable,, Pro-
ceed as follows:
1. Turn unit off and disconnect spark plug
wire from spark plug.
2. Turn nut on underside of drive control
to increase drive speed.
3. Operate mower to test drive speed.
Readjust as required°
4. if condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels
for high cut, adjust cutting height to suit
your requirements. Medium position is
best for most lawns°
° To change cutting height, squeeze ad-
juster lever toward wheel° Move wheel
up or down to suit your requirements. Be
sure all wheels are in the same setting,
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
LEVER BACKWARD Plate tab
TO LOWER MOWER
LEVER FORWARD TO RAISE MOWER Lever
"r
rr
= E
I_ z
o
O_ rr
o
Ill r_ -r
m
x
o
!
!
m
0
>.
0
< r-.
r_
wd
8