Publicidad
Idiomas disponibles
Idiomas disponibles
8. When fitting the blade, make sure it is installed in
the right direction as shown in the figure. The raised
points on the positioner must be aligned with the
holes in the blade.
9. Retighten the mounting bolt. Recommended
tightening torque should be approx. 33-37 Nm.
6.3
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose
or damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service
center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the
machine.
7
TROUBLESHOOTING
Problem
Possible cause
The handle is
The bolts are not
not in position.
engaged correct-
ly.
The machine
The battery ca-
does not start.
pacity is low.
The handle
switch is defec-
tive.
The safety key is
not put in.
The machine
The lawn is
cuts grass un-
rough.
evenly.
The blade height
is not set cor-
rectly.
The machine
Wet grass clip-
does not mulch
pings attach to
correctly.
the deck.
The mulch plug
is missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
English
Problem
There is a high
vibration in the
machine.
The machine
stops during
mowing.
Solution
Adjust the height
of the handle
and make sure
* If you cannot find the solution to these problems, go to
that the knobs
the service center.
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the han-
dle switch.
Put in the safety
key.
Examine the
mowing area.
Adjust the blade/
cutting height to
a higher position.
Wait until the
grass dries be-
fore mowing.
Install the mulch
plug.
Increase the
blade/cutting
height.
7
Possible cause
Solution
The grass catch-
Empty the grass
er and the blade
clippings from
drags in thick
the grass catch-
grass.
er.
The blade is un-
Replace the
balanced and
blade.
worn.
The motor shaft
1. Inspect for
is bent.
damage.
2. Repair the
machine be-
fore you start
it again.
The blade height
Increase the
is too low.
blade/cutting
height.
The battery pack
Charge the bat-
is out of power.
tery pack.
The grass clip-
Remove the bat-
pings attach to
tery pack and
the deck or the
check the deck.
blade.
Operation tem-
Cool the ma-
perature of the
chine.
machine is too
high.
EN
Publicidad
