Black and Decker LDX220 Manual De Instrucciones página 4

• When not in use, place tool on its side on a stable surface where it wM not cause a
tripping or falling hazard. Some tools with large battery packs will stand upright but may
be easily knocked over.
• Keep your hair, clothing, and gloves away from air vents. Air vents often cover
moving parts in which these items can be caught.
• Hold tool firmly with two hands, one hand on the handle, and the othergripping the
bottom around the battery area. Use auxiliary handle if provided. Loss of control can
cause personal injury.
z_WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
, arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
_WARNING:
Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
z_WARNJNG:
ALWAYS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87. 1 eye protection (CAN/CSA Z94.3)
ANSI S12.6 ($3. 19) hearing protection
NIOSH/OSHA/MSHA respiratory protection
The label on your tool may include the following symbols.
V .......................... volts
Hz ........................ hertz
min ........................ minutes
- - - ...................... direct current
[] .......................... Class II Construction
z_ ........................ safety alert symbol
A .......................... amperes
W ........................ watts
,x, ...................... alternating
current
no ........................ no load speed
G ........................ earthing terminal
.../min .................. revolutions or
reciprocations per minute