Publicidad
Idiomas disponibles
Idiomas disponibles
32
TROUBLESHOOT
NG
BEFORE
CALLING
FOR SERVICE
(confinued)
Wrinkling
Excessivesudsing
Staining
Washer not unloaded promptly.
Washer overloaded.
Hot and cold water inlet hoses are
reversed.
Too much
detergent
or incorrect
detergent.
Bleach or softener
dispensed
too
soon.
Bleach or softener
was added di-
rectly to the wash load in the tub.
Washer was not unloaded prompt-
ly.
Clothes were not properly sorted.
ilill ii!i!i_!ii!ii
iii!i!
i!i!i!_!i!_!_!_!_
!ii!ii!ii!ii!ii!iiiii_il
i_!_i_
iiiiiiiiiiiill
i_i!_
i!_ii_iii!!ii_
_i!_ii_
i!_ii_i!_ii_i!_i
i_i!_ii_
i!_ii_ii
!ilil iiii_i_iiiiiiiiiiii
iiiiii
iiii_ii_ii_ii_ii_iiiii
i_ii_ii_
ii_ii_ii_iiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiil
ii!_;
_i_i_i!_
_!i_ii_ _!_ii!!ii_iiiiii
iiiiiiiiiiiiiiii!ii!ili!
i!iiiill
iii!!iiiiii!ili!i_i!iiiiii
iiiiiiii
iiiiiiiiiiiiiii
iiiiii_
ii_i!_!i_ii_!i_i
iiiiiiiiili!_!
_!_!!_!_!!_!!
!!!!!!
!!!!i
!!!i!
i!i!i_!_i!!ii!!!!ili
i_i_!i_i_ii_ii_
ilili!!_!_!i_!
!i_!i_!i
_!i_!ii_i!_
Always remove items from the washer as soon as the
cycle is complete.
The washer can be fully loaded, but the tub should not be
tightly
packed with items. The lid of the washer should
close easily.
Hot water rinse can set wrinkles
in garments.
Check the
inlet hose connections.
HE detergents
are formulated
specifically
for High-Effi-
ciency washers and contain suds-reducing
agents. Only
use detergent with the High-Efficiency
(HE)logo.
For de-
tergent quantities
refer to the How to Use section.
Dispenser
compartment
is overfilled
causing bleach or
softener
to dispense
immediately.
ALWAYS
measure
bleach to prevent overfilling - one cup maximum.
Dispenser drawer closed too quickly causing softener to
dispense immediately.
Always use the dispensers to ensure that laundry prod-
ucts are properly dispensed at the right time in the cycle.
Always remove items from the washer as soon as pos-
sible after the cycle is complete.
Always wash dark colors separately from light colors and
whites to prevent discoloration.
Never wash
heavily soiled
items washed
with
lightly
soiled items.
Make sure that the plug is plugged securely into a ground-
ed, 3-prong, 120-VAC, 60-Hz outlet.
Reset circuit
breaker or replace fuse. Do not increase
fuse capacity.
If the problem is a circuit overload, have it
corrected by a qualified electrician.
Washer will not turn
Power cord is not properly plugged
ON
_n,
House fuse is blown, circuit break-
er has tripped,
or power
outage
has occurred.
NOTE: If the washer stopped during a cycle due to a loss of power, the washer will resume
the cycle where it stopped when the power is restored.
Wash cycle time is Ion- The washer
automatically
adjusts
This is normal. The washer adjusts cycle time automati-
get than usual
the wash time for the amount of cally to provide optimal results for the selected cycle. The
laundry, water pressure and other
time remaining shown in the display is only an estimate.
operating conditions.
Actual time may vary.
Musty or mildewy
odor Incorrect
or too
much detergent
Use only High-Efficiency
{HE) detergent
in accordance
in washer
has been used.
with the manufacturer's
instructions.
Inside of tub was not cleaned prop- Run the Tub clean cycle regularly.
erly.
Water leaks
Oversudsing
of detergent.
Oversudsing
may create leaks, and may be caused by the
type and amount of detergent
used. High-Efficiency
de-
tergent
is the only detergent
recommended.
Make sure
that detergent
and any additives
are put into the correct
dispenser
compartments.
The normal amount of deter-
gent to use is I/4 to 1/2 of the maximum amount recom-
mended
by the detergent
manufacturer.
Always
reduce
the amount
of detergent
if the load is small or lightly
soiled, or if your water is very soft. Never use more than
the maximum
amount recommended
by the detergent
manufacturer.
Publicidad
