LEGRAND C2G Manual página 5

HDMI® HDBaseT + USB-B to A and RS232 over Cat Extender Box Transmitter to
Box Receiver (18Gbps) - 4K 60Hz up to 328ft
Product Overview
Front Panel
① ② ③ ④ ⑤
F P D
RONT ANEL ESCRIPTION
On: Power is applied to the device.
1 P LED
OWER
Off: No power is applied to the device.
On: HDBT link is normal.
2 L LED
INK
Off: No HDBT link or link error.
On: HDMI input signal is active.
3 V LED
IDEO
Off: No HDMI input signal or HDMI input signal is inactive.
4-Pin DIP Switch for settings of RS232 working mode (RS232
pass-through, Valens firmware upgrade and MCU firmware
4 SET
upgrade). For more information, see "DIP Switch Settings" section.
Connect to an audio receiver for audio pass-through from
AUDIO OUT
5
transmitter to receiver.
(PASS THROUGH)
USB 2.0 Type-A port. Connect to USB devices (e.g., keyboard,
mouse, USB camera, USB flash drive, etc.).
Note: USB ports support USB 2.0 standards with a maximum of
6 4x USB-A D
EVICE
1.4A for the top two ports and 0.6A on the bottom two ports. USB
cameras are recommended to be connected into one of the top two
1.4A ports.
Receiver
⑥
Rear Panel
⑦ ⑧
R P D
EAR ANEL ESCRIPTION
Connect to the power adapter provided. With one-way PoH function
7 DC 12V supported, one power adapter is needed to connect to the receiver
to power both units.
Connect to a RS232 device for bi-directional RS232 pass-through
8 RS232
or firmware upgrade.
9 HDBT IN Connect to the transmitter.
10 HDMI OUT Connect to an HDMI display device using an HDMI cable.
AUDIO OUT
Connect to an audio receiver (e.g., speaker) for audio de-
11
embedding output.
(DE-EMBED)
12 ETHERNET Connect to a network or a PC for ethernet pass-through.
3
Receiver
⑨ ⑩ ⑪
(us)
(us)
⑫