70mai X200 Manual Del Usuario página 6

Installation
1. Selecting mounting
position
Mount the dash cam on
either of the recommended
positions of front windshield as
appropriate: 1. Near the center
of rearview mirror; 2. On the
front of the passenger seat.
Notes:
Make sure the camera is below the level line of the rearview
●
mirror.
Attach the electrostatic sticker on the selected position, with
●
the gap image facing upwards. Press the sticker to remove air
bubbles out.
Keep windshield clean and dry without liquid residue to
●
prevent the sticker from losing adhesion and dash cam from
dropping.
2. Installing the dash cam
Paste the dash cam on the electrostatic
sticker.
Make sure the gap on the adhesive sticker
aligns with that on the electrostatic sticker
and the display screen faces the car interior.
3. Routing cable
Route the power cord to the
cigarette lighter and connect to
power.
Notes:
Use the included crowbar to hide the power cord
●
underneath the vehicle's headliner and rubber seal
along the A-pillar.
Depending on the vehicle, the cigarette lighter socket
●
may be located in a different position. The figure
provided is for reference only.
4. Adjusting the dash cam angle
Hold the dash cam and turn the dash
cam up and down to adjust the dash
cam angle based on the preview
screen.
Installing/uninstalling the mount
The mount is pre-installed on the dash cam. If you need to
uninstall it, follow the steps below:
Uninstalling the
mount:
Hold the
dash cam and screw it
clockwise and then the
dash cam will separate
with the mount.