Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
the position of each accessory in case you
need to repack it in the future.
The fan is packed with the grilles removed.
You must place the grilles before operating
the fan.
Warning: Never operate the fan without its
base or other parts.
Operate the fan only in an upright position;
any other position could create a dangerous
situation.
Assemble the base and other parts of the
appliance considering the following notes.
Note: the images are for guidance only and
should be used to support the installation.
Follow these steps to assemble the product
(See image sequence 03 on page 5):
• Put the back grille aligned with the
motor, make sure the handle is on the
top part and fix it with the 4 screws
supplied.
• Insert the blades in the motor axis and
tighten the screw on the blades to fix
them.
• Loosen up the front grille screw.
• Turn front grille bracket and
• Tighten the previously loosened screw
for the correct fixation of both grilles.
• Place the motor with the grilles on the
tube (metal arm) and fix it with the
screws.
• Place the tube (metal arm) on the base
of the wall and fix it with the screws.
Follow the steps below to install the product
(See image sequence 03 on page 5):
• Select an appropriate location to install
your fan taking into account that your
product needs a plug and the cable has
the specific dimension.
• You should also note that the controls
are located at the rear and you should
be able to access them easily.
• Take the dimensions of the base-to-
wall piece and mark them on the wall.
• Do the four holes in the wall with a drill.
• Attach the wall bushings (may not be
20
supplied) and attach the base-to-wall of
the product with the screws.
• Plug in the power plug.
• If the power cord hangs loosely between
the fan and the power outlet, make
sure that it cannot touch or obstruct
the rotation of the fan blades or the
oscillation of the fan at any time.
Note: Please keep in mind that the product
wall base can be assembled to the product
and then be installed on the wall or
installed on the wall and then assembled
to the motor with the grilles.
USING THE APPLIANCE
This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel
See the image 02 on pago 4)
12. Speed knob: turn the knob to select
the speed. Choose from the three
speeds. Set the knob to 0 if you want
to turn the product off.
13. Swing button: press down to activate
the swing or press up to deactivate it.
CLEANING AND MAINTENANCE
Para limpiarlo, por favor siga las siguientes
instrucciones:
• Turn the fan off and wait until it has
stopped completely.
• Disconnect it from the power supply.
• Be careful to prevent any liquid from
getting inside the appliance.
• Use only a soft damp cloth.
• Do not allow water at a high temperature
in contact with the plastic parts.
• Do not use abrasive cleaners. You can
use a neutral detergent.
• When you have finished cleaning it,
assemble it again and store it in a dry
place.
• If you are not going to use the fan
for some time, it is recommended to
remove the batteries from the remote
Publicidad
