Publicidad
Idiomas disponibles
Idiomas disponibles
Removing and installing abrasive
belt
Pull the cam lever back to release the tension in the
belt, and remove the belt.
To install the belt, place one side of the belt over the
rear pulley in first, hook the other side over the front pul-
ley, and then set the cam lever to the original position.
3
► 1. Cam lever 2. Abrasive belt 3. Rear pulley 4. Front
pulley
Adjusting belt tracking
Make sure that the belt is aligned with the arm properly
on a trial run at low speed.
Use the thumb screw to center the belt tracking. Turn
the screw clockwise to incline the arm to the right when
looking down at the tool with its arm pointed forward,
and in counterclockwise to the left.
1
► 1. Arm 2. Thumb screw
1
2
2
Installing side grip
CAUTION:
before operation.
CAUTION:
force on the side grip, otherwise the grip base
becomes loosely attached and the tool may fall
off causing damage or personal injury in the fol-
lowing conditions:
4
•
Apply a full impact on the side grip during
operation
•
Handle the tool carelessly only with one hand on
the side grip
•
Carry the tool only with one hand on the side
grip
The side grip (auxiliary handle) helps hold the tool firmly
during operation.
1.
Screw the grip into the fastening nut placed in the
grip base.
► 1. Grip 2. Grip base 3. Fastening nut
2.
Loosen the thumb screw in the grip base.
Attach the base to the barrel of the motor housing align-
ing the locking tab on the base with the shallow groove
in the surface of the housing.
Tighten the thumb screw to secure the grip.
► 1. Thumb screw 2. Motor housing
8 ENGLISH
Securely tighten the thumb screw
Avoid exerting a strong external
3
1
1
2
2
Publicidad
