Publicidad
Idiomas disponibles
Idiomas disponibles
Shut Off
1. Release wheel drive control and allow
unit to stop completely
(self-propelled
models).
2. Release engine/blade
control.
MOWING TIPS
Cut grass when it is dry.
Keep mower blades sharp.
Do not set cutting height too low. For tall
grass, mow twice.
Do not mow too fast.
Mow with engine at full throttle. Discharge
clippings into areas already cut.
Vary cutting pattern with each mowing.
NOTE: To prevent dirt and grass from
collecting on mower pan, avoid operating
over bare ground with only patches of grass.
Mulching
Tips
For best mulching performance,
cut no more
than 1 inch (2.54 cm) of grass per cutting.
CAUTION:
AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Ariens Dealers will provide any service, parts
or adjustments which may be required to
keep your unit operating at peak efficiency.
Should engine require service, contact an
Ariens Dealer or an authorized engine
manufacturer's
service center.
MAINTENANCE
SCHEDULE
NOTE: Some working conditions
(heavy
loads, high ambient temperatures,
dusty
conditions,
or airborne debris) may require
more frequent service.
See engine manual for further maintenance
and troubleshooting
information.
Service Performed
Check Engine/Blade
Control
Check Wheel Drive
Control
Check Grass Bag
Clean Unit
Check Engine Oil
Check Mower Blade
Check Drive Belt
Check Fasteners
Check Air Cleaner
Change Engine Oil
Replace Oil Filter
General Lubrication
Check Spark Plug
Check Engine
Cooling
Check Muffler
Replace
Engine/Blade
Control
Cable
After first 5 Hours of operation.
_
Replace Engine/Blade
Control Cable
every 500 Hours of operation.
GB- 15
Publicidad
