Descargar Imprimir esta página

Ariens Pro21 Manual Del Propietário página 22

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: Before adjusting
the wheel drive
cable, first m ake sure the area around the
drive c omponents
isfree ofdirt o rdebris that
could p revent the transmission
from engaging
ordisengaging
properly,
and then make sure
the return spring isconnected
properly
to
idler arm.
Adjust the wheel drive b y adjusting
the cable
onthe handlebar.
IMPORTANT:
DO NOT a djust the cable s o
the transmission
does n ot r eturn toneutral
and stop the unit w hen t he control bail i s
released.
Check
the adjustment
1. Start the engine and slowly squeeze the
wheel drive control against the
handlebar and then release the wheel
drive control.
2. The unit should move forward as you
squeeze the wheel drive control and
then stop immediately and not "creep"
slowly forward when you release it.
To adjust:
1. Move the wheel drive cable adjuster up
or down the handlebar. See Figure 19.
To increase
traction
and speed, move
the cable adjuster down the handlebar.
To decrease traction
and speed, move
the cable adjuster up the handlebar.
2. Check the adjustment
and readjust as
needed.
Cable Adjuster
Figure 19
CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT:
NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
Allow unit to cool. Clean unit thoroughly with
mild soap and low pressure water. Brush off
dirt and debris from all surfaces. Touch up all
scratched surfaces to prevent rust. Matching
touch-up paint is available from your Ariens
Dealer. Do not use abrasives, solvents, or
harsh cleaners.
Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass
Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
Engine
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to engine manual.
GB - 22

Publicidad

loading

Este manual también es adecuado para:

911271