Matikgate Flow Manual Del Usuario / Instalador página 40

MOTOR INSTALLATION
EN
Install the motor on the mounting plate. Fix with the 2 M8x110mm screws provided.
To install the automation on the right leaf, change the position of the automation and use
other pairs of holes.
INSTALLATION OF ARMS
Insert the straight arm into the reducer drive shaft. Level the ends of the shaft and arm,
secure the washer with the M6x20 screw and secure the arm shaft with 2 pairs of fixing
screws.
Connect the 2 arms using the M8X16 screw and washer. Unlock the reducer by turning
the crank clockwise and fix the curved arm to support A using the M12X50 screw and
M12 nut.
When installing the automation on the right leaf, follow the installation procedure in the
image shown above on the right.
40
MATIKGATE AUTOMATION