Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the LEFT END (B3) until the shoulders of the SCREWS
rest on the surface of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide one END MOLDING (M73) onto the LEFT END (B3).
Line up the groove in the MOLDING over the heads of the
SCREWS in the END.
å
NOTE: The MOLDING should be centered on the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
www.sauder.com/service
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
B3
411201
Just think. The sooner
you do this, the sooner
you do something else.
32S
M73
Shoulder
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
0
Page 7
Publicidad
