Publicidad
STEP 5:
Attach the Sliding Rail (No. 5) to Main
Frame (No. 1) using Bolt (No. 81), 2
Washers (No. 60), and Nut (No. 64).
Tighten and secure with Spanner (No. 75)
and Allen Wrench (No. 74).
Next, attach the top of the Sliding Rail
(No. 5) to the Main Frame (No1), insert the
Pull Pin (No. 82), then use Knob (No. 80)
to tighten.
STEP 6:
Take out 2 AA
bag with the manual. Push Computer (No.
32) upward, then remove Computer (No.
32) from Main Frame (No. 1). Disconnect
Sensor Wire (No. 34) and the wire of
Computer (No. 32). Install the 2 AA
batteries into the back of Computer (No.
32).
STEP 7:
NOTE: The two upper buckles of
Computer (No. 32) should be aligned to
the two upper slots of computer seat of
Main Frame (No. 1).
Connect Sensor Wire (No. 34) with the
wire of Computer (No. 32). Place
Computer (No. 32) back onto the Main
Frame (No. 1), then push the Computer
(No. 32) downwards to fit into position.
The assembly is complete!
-38-
batteries from the plastic
Publicidad
