DeWalt D55150 Manual De Instrucciones página 16

5135175-02,01.qxd 3/30/05 8:32 PH Page 14
'\ b/
Code Possible Cause
25
ressure re on pressure sw qas
not :led
Pressure switch does not shut off motor when
air compressor reaches "cut-out" pressure.
27 Defective switch.
31 Fittings nottight enough.
33 Pressure regulator knob not turned to high enough
35 Possible defective reed valve.
41 Compressor located in damp or humid location.
Possible Solution
sts,
contact DEWALT customer service at 1-800-4-DEWALT.
Move the pressure switch to the OFF position.
If the motor does not shut off, unplug the air compressor. If the
electrical contacts are welded together, replace the pressure
switch.
Re switch.
Warning: Drain air before tightening. Tighten fittings so air can
not be heard escaping. Check joint with soap solution. Do not
Adjust pressure regulator knob to proper setting or replace.
Remove pump head and inspect valve plate and reed valve.
Clear or re valves as re( uired.
)er level with
Relocate the compressor.
14
........ _qN ...