Publicidad
Idiomas disponibles
Idiomas disponibles
5135175-02,01.qxd
3/30/05
8:32
PH
Page
5
'\ b/
[ HOT SURFACES
PUMP
PUMP CYLINDER
PUMP
HEAD
AFTERCOOLER
will remain hot for several minutes after operation. Do
not move the compressor while it is running. Hot motor
parts could cause burns contributing to the dropping of
the compressor,
damaging
the compressor
and/or
injuring the operator.
RISK FROM NOISE
_,CAUTION:
Wear
appropriate
personal
hearing _
protection
during
use. Under some
conditions
and
duration of use, noise from this product may contribute to
hearing loss.
Introduction
Congratulations
on the purchase
of your
new DEWALT Air
Compressor! You can be assured that this tool has been constructed
with the highest level of precision and accuracy. Each component
has been rigorously tested by technicians
to ensure the quality,
endurance and performance of this air compressor.
By reading the following
simple safety, installation,
operation,
maintenance
and troubleshooting
steps described in this manual,
you will receive years of trouble-free operation.The
manufacturer
reserves
the right to make changes
in price, color, materials,
equipment specifications, or models at any time without notice.
Inspection
of Compressor
Inspect for signs of obvious or concealed freight damage. Report any
damage to the delivering freight carrier immediately. Be sure that all
damaged
parts are replaced and any mechanical
problems
are
corrected
prior to the operation
of the air compressor.
The air
compressor
serial
number
is located
on the shroud
of the
compressor. Please write the serial number in the space provided in
the service section for future reference.
_, WARNING: When using electric tools, basic safety precautions
should always be followed to reduce risk of fire, electric shock, and
personal injury.
DEWALT
Air Compressor
Features
PRESSURE SWITCH
This switch (A) is used to start or stop the air compressor. Moving the
switch to the ON position
will provide
automatic
power to the
pressure switch which will allow the motor to start when the air tank
pressure is below the factory set cut-in pressure. When in the ON
(AUTO) position, the pressure switch stops the compressor from
charging air when the air tank pressure reaches the factory set cut-
out pressure limit. For ease of starting, this
switch also has a pressure
release valve
located on the side of the switch designed to
automatically release compressed air from the
air compressor pump head and its discharge
line when the air compressor reaches the cut-
out pressure limit or is shut off. Moving the
switch to the OFF position
will open the
pressure
switch contacts
and stop the air
compressor.
........
_N:Y . ..
Publicidad
