GE GTH21 Manual Del Propietario E Instalación página 13

Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
• CAUTION -
the
Refrigeratoi: To elimilmte tile danger
of electric shock during installation,
VOtl II, tlst UI,l)lug tile refligerator fl'om
its electrical outlet.
TOOLS YOU WILL NEED
Flat bladeandPhillips Pliers
screwdrivers
PARTS INCLUDED
2 3
NO. DESCRIPTION QUANTITY
1 Water FillTube 1
2 IceFill Guide 1
3 Water FillTubeSeal 1
[] INSTALL FILL TUBE
• If tile reli'igerator ah'eady has a
water tube inlet on tile back of tile
refl'igerato_; go to Step 2.
• Remove and discard tile white plug
ti'om the lower left back corner of
the fl'eezer wall.
• Go to tile back (ff tile refligerat(n: Find tile small
label in tile upper right hand corner and peel it
off. Then discard the label.
• Peel one side of tile paper away Seal
fl'Oln the water fill tube seal, slide
the seal along the tube and affix
to the back side (ff the water
tube inlet flange.
• I_.emove the adhesive
backing on the opposite side
of tile water fill tube seal and
slide tile tube into tile hole I
near tile top at tile back of tile refl'igerator. Fimdy
press on tile inlet to secure it to tile reflJgerator
[] REMOVE THE OUTLET COVER
• ]_.ell, O_,e
tile outlet cover
with a fiat-blade screwdrixer.
Side Back
I_PREPARE FOR INSTALLATION
Inside tile freezer; loosen tile two mounting screws,
but do not scI'ew them all tile way otlt. If )ore" model
does not haxe tile screws alreadx in tile freezer wall,
look for two I)lug buttons. Relnoxe tile I)lug buttons
and insert the two Phillips head screws, The screws
should extend approximately 1/2" (131,,1,,) out
from the freezer wall.
Mounting
screws
I_SET POWER SWITCH TO O (off)
Set tile icema_ker power switch to 0 (off). I.eave
the power switch in tile 0 (off) i)osflion until tile
reflJgerator is coi, nected to tile water sui)ply to
l)revent l)relnature operation.
Power
Switch
Holefor
wire tie
(Appearancemay vary)
13