GE GTH21 Manual Del Propietario E Instalación página 15

Installation instructions
[] ATTACH THE WATER VALVE
• Locate the temale connector plug. Plug the
female connector onto the male terminals on
the water valve. Either wire can go on either
terminal.
Female
connector_._.j [
terleinals
• Fasten the water xalxe to the cabinet by drixing
the Phillips head screw from the kit into the hole
in the cabinet leg.
., Plilillipshead
[] CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend fl'om the water wdve to well into the
water tube inlet. Cut off any excess tubing.
• Squeeze the ends of the hose damp fl'om the
kit with pliers and slide the clamp over the water
tube inlet.
• X_]_ile still squeezing the clamp, insert the plastic
water line into the inlet as flu" as it will go
(approximately 1" [25 mm ]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet 7_
Hose clam
[] INSTALL WATER LINE CLAMP
• Attach the metal water line clmnp (strain relief)
to the refrigerator. Drive the screw from the kit
through the clamp at the indent into the back
of the cabinet.
• The metal clamp is for the house water line (see
the _'ater I,ine Installation Instructions). It is not
to be used fl)r the tubing fl'om the water wdve up
to the icemaker,
i
Screw _ Strain
¢ ,_[ _ relief
[] ROUTE AND ATTACH THE
PLASTIC WATER LINE
• Fasten the plastic water line to the back
of the cabinet with adhesive-backed fasteners,
spacing the tasteners as shown to take up slack
in the line.
/
Adhesive-backed f asteners
for plasticwater line
15