GE GTH21 Manual Del Propietario E Instalación página 22

Installation Instructions
REVERSING THE DOOR SWING
(CONT.)
[] REMOVE FREEZER DOOR
%_I_e the door shut with masking tape.
Remove the hinge cover on top ot the fl'eezer doo_:
Remove the four screws with a 5/16" socket and
ratchet, then liti the hinge straight up to ti'ee the
hinge pin ti'om the socket in the top oI the doo_:
TopHinge
Remove the tape and tilt the door away fl'om the
cabinet. I,itt it off the center hinge pin.
NOTE: Do not misplace the washer located on the top
side (ff the center hinge pin.
Set the door on a non-scratching s/irt;ice with
the inside up.
[] REMOVE REFRIGERATOR DOOR
%_I_e the door shut with masking tape.
Remove the center hinge by removing two hinge
screws with a 5/16" socket and ratchet, i,ift the
hinge pin up and out of the door.
NOTE: Do not misplace the washer located on the
underside of the center hinge pin.
PlasticWasher_z
HingePin
Center H inge//
Bracket
/
i
i
Fresh FoodDoor
Remove the tape and tilt the door away fl'om the
cabinet, i,ift the door straight up to fl'ee its bottom
socket fl'om the pin in the bottom hinge bracket.
Set the door on a non-scratching surti_ce with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
[] TRANSFER TOP HINGE TO
THE LEFT
Interchange hinge and screws at top right with scre_:s
at the top left of cabinet.
Do not tighten screws on hinge side at this time,
[] TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remo_ e it by ,grasI_ing, it
abotlt 6" I'i'on/each end and I_ullin'"_ its bottom edge
toward VOtl.
L)sing a 5/16" socket and ratchet, remove the 3 screws
ti'om the bottom hinge. Taking care not to misplace
the washer on the bottom hinge, move the bottom
hinge ti'om the right to the lett side.
NOTE: If the washer is not on the hinge bracket,
check to see if it is stuck to the bottom _ff the door.
Plastic
i
_:_..,L_----Washer
Bracket
Replace
the base grille by inserting
the tops of the
metal clips into the oval vents, making sure one ot the
plastic tabs on the back of the grille goes into each of
the owd vents. Then push the bottom of the grille
forward until it snaps into place.
22