GreenWorks G48LT30 Manual Del Operario página 5

3.3 ASSEMBLE THE SHAFT
Figure 4.
1. Unlock the cam lever.
2. Insert the lower shaft through the guide groove until you
hear a "click".
3. Adjust the shaft to the most suitable position.
4. Lock the cam lever.
3.4 ATTACH THE AUXILIARY
HANDLE
Figure 3.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the auxiliary handle with the knob.
3.5 INSTALL THE BATTERY PACK
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 6.
English
1. Pull back on the lock-out button and pull the trigger.
4.2 STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 6.
The machine has an auto-feed head. It will damage the
machine if you hit the head to try to advance the line.
If the cutting line does not automatically advance, it can be
tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
4.4 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
Figure 7.
1. Stop the machine.
2. Push the spool retainer button and pull on cutting line to
manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it again.
4.5 CHANGE TO THE EDGING MODE
Figure 8.
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Push on the edge button and turn the trimmer head 90
degrees until the trimmer head locks into position.
3. Release the edge button.
4.6 PIVOTING HEAD FUNCTION
Figure 9.
5
NOTE
NOTE
NOTE
NOTE
EN