Jepson SHDC 8320 Instrucciones De Servicio página 11

7. FUNCTIONAL DESCRIPTION
7.1. INTENDED USE
This saw is designed exclusively for the
sawing of
sandwich panel, aluminum, steel and
plastics. This machine should not be
used for cutting other materials. Do not use this saw
to cut wood. The machine should not be converted
or modified, e.g. for any other form of use, other
than as specified in these operating instructions.
The user shall be liable for damages and accidents
due to incorrect use.
CAUTION: Do not overheat the blade
tips. Use of undue force will not
speed up the cutting operation.
Allow the tool to determine the best
feed rate.
CAUTION: When sawing plastics, avoid melting
the plastic.
7.2. ELECTRICAL CONNECTION
The network voltage must conform to
the voltage indicated on the tool name
plate. Under no circumstances should
the tool be used when the power
supply cable is damaged. A damaged cable must be
replaced immediately by an authorized Customer
Service Center. Do not try to repair the damaged
cable yourself. The use of damaged power cables
can lead to an electric shock.
7.3. EXTENSION CABLE
If an extension cable is required, it must
have a sufficient cross-section so as to
prevent an excessive drop in voltage or
over-heating. An excessive drop in
voltage reduces the output and can lead to failure
of the motor. The following table shows you the
correct cable diameter as a function of the cable
length for this machine. Use only U.L. and CSA listed
extension cables. Never use two extension cables
together. Instead, use one long one
Total Extension Cord
Length (feet)
25
50
100
150
200
rigid insulation panel,
Cord Size (AWG)
16
12
10
8
6
SUPER HAND DRY CUTTER 8320
7.4. SAW BLADE
Only use original saw blades with a
diameter in accordance with the
markings on the tool name plate:
Only use saw blades with blade set
(cutting width) of 2.2 mm and blade thickness 1.8
mm.
Saw blades must be suitable for speeds of up to
1700 min -1or faster. Do not use any abrasive wheel
with this machine.
7.5. UNPACKING
Carefully remove the tool and all loose items from
the shipping container. Retain all packing materials
until after you have inspected and satisfactorily
operated the machine.
NOTE: An appropriate blade must be mounted
to the machine before operating. Refer to the
section of this manual: "INSTALLING THE SAW
BLADE"
Carton contents:
• SUPER Hand Dry Cutter 8320
• Original Jepson carbide tipped saw blade
320x2.2x25.4x84T
• M5 L-hex key
WARNING! DO NOT OPERATE THIS
TOOL UNTIL
UNDERSTAND
INSTRUCTION MANUAL
7.6. INSTALLING THE SAW BLADE
Inner arbor flange ENSURE THAT THE MACHINE IS
DISCONNECTED FROM POWER
SOURCE
To install the blade:
Remove any accumulated debris in
the guards and around the arbor.
Clean the inner arbor flange. Orient the flange so
that the correct side faces the blade and place the
new blade on the arbor,
making sure that the teeth point forwards.
Place the outer arbor flange on the arbor with the
correct side toward the blade.
NOTE: Use blades that have an arbor bore which
can fit, and that are rated for the machine's
YOU READ AND
THE ENTIRE
11