Publicidad
Idiomas disponibles
Idiomas disponibles
RIVETER PREPARATION
The rivet must be prepared for the rivet nut size.
The following cap nuts and rivet nut holder for setting the rivet nuts are included.
Cap nut M3
Rivet nut holder
M3
MOUNTING MOUTHPIECE / RIVET NUT HOLDER
Loosen the cap nut by using wrench
1.
Spread lever arms; press out the retaining bolt
3.
5. Install the required rivet nut holder and cap nut in reverse order.
WORK PIECE PREPARATION
Make a hole in the work piece by drilling or punching (Fig. 1).
Note: The opening must be free of burrs.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Cap nut M4
Cap nut M5
Rivet nut holder
Rivet nut holder
M4
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Cap nut M6
Rivet nut holder
M5
M6
Remove the cap nut
2.
Remove the rivet nut holder
4.
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Cap nut M8
Rivet nut holder
M8
Publicidad
