Linsar YLW6336 Manual Original página 68

2. Press the 3 on/off button.
3. Press the watering button 6 and spray the area to be cleaned with clean water.
4. Press the suction inlet 15 of the water vacuum (13 / 14 ) on the area to be cleaned
and vacuum it thoroughly.
5. Allow the cleaned area to air dry.
6. Press the 3 on/off button.
7. Unplug the mains cable 10 from the socket.
8. Clean the device (see chapter "Cleaning").
Cleaning
NOTE!
If water or other liquids enter the housing, they can cause a short
circuit.
- Never immerse the unit in water or other liquids.
- Make sure that no water or other liquid gets inside the housing.
NOTE!
Improper handling can damage the device.
- Do not use any aggressive cleaners, sharp or metallic cleaning
utensils such as knives, hard scrapers or similar items. These
could damage the surfaces.
- Do not hose the device down with water.
1. Disconnect the device from the power supply.
2. Remove and clean the fresh water tank 4 and the dirty water tank 1 (see chapter
"Cleaning the fresh water tank" / "Cleaning the dirty water tank").
3. Remove all accessories and the suction hose and clean them under running water.
4. Remove any blockages.
5. Wipe the surfaces of the appliance clean with a clean, damp cloth.
6. Allow all parts to dry completely before reassembling the device.
Risk of short circuit!
Risk of damage!
68