Craftsman 580.752860 Manual De Instrucciones página 13

NOTICE You must attach all hoses before you start the
pressure washer.
8. Start the pressure washer as instructed in How to Start
Your Electric Pressure Washer.
9. Apply detergent to a dry surface, starting at lower portion
of area to be washed and work upward using long, even,
overlapping strokes.
lO.AIIow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as needed to prevent
surface from drying. To prevent streaking, Do Not allow
detergent to dry on surface.
ElectricPressure Washer Rinsing
1. Remove black detergent spray tip from metal wand.
2. Select and install desired high pressure spray tip
following instructions How to Use Spray Tips.
3. Keep spray gun a safe distance from area you plan to
spray.
WARNING Risk of kickback.
_ Spray gun could kickback causing you to fall
resulting in death or serious injury.
• Operatethe electric pressure washer from a
stable surface.
• Be extremely careful if you must usethe electric pressure
washer from a ladder, scaffolding, or any other similar
location.
• Firmly grasp spray gun with both hands when using
power spray modes to avoid injury when spray gun kicks
back.
4. Apply a high pressure spray to a small area and then
check surface for damage, if no damage is found, you can
assume it is okay to continue rinsing.
5. Start at top of area to be rinsed, working down with same
overlapping strokes as you used for cleaning.
Other Cleaning Tips
• NEVERleavethe electric pressure washer unattended
while it is plugged into an electrical outlet and while
water is supplied to the equipment.
• If you havethe nozzle too far away from the surface
being washed, the cleaning may not be as effective.
How to Usethe Steam Function
NOTICE Use ONLYdistilled / demineralized water. DO NOT
use any other liquids that could be flammable or could clog
up the system.
1. Rotate water tank cap (A) clockwise to releasefrom
retaining tab. Removecap from water tank (B).
/
2. Fill tank with clean distilled / demineralized water (B).
NOTICE To ensure that your unit operates optimally and
lasts a long time, use ONLYdistilled / demineralized water.
Limestone deposits could compromise the unit's normal
operation (intermittent steam supply, water leaks from the
relief valve, nozzle and supply pipe clogging), if this occurs,
please contact Sears Customer Service.
.
4.
.
Place suction tube and cap back into water tank.
Rotate water tank cap (O) counter-clockwise until it clicks
onto retaining tab. Make sure that end of suction tube
contacts bottom of tank.
Make sure the shroud (F) and brush attachment (G) are
installed on the steam gun (B). The shroud is secured by
a spring loaded button (E) on the gun. Push this button in
to install and remove the shroud. The brush attachment
tightly slides over the shroud end.
NOTICE Garden hose and high pressure hose do not need to
be connected to use the steam function.
6. Perform Steps 6, 7 and 8 in How to Start Your Electric
Pressure Washer.
A WARNING Hot Surface and Steam Burn Hazard.
Hot surfaces and steam produced by the steam gun
could cause burns resulting in serious injury.
• DO NOTtouch the steam jet or nozzle end with your
hands during use.
• Allow equipment to cool before touching.
• ALWAYSpoint steam gun in safe direction while system
is operating.
• DO NOTaim steam gun at people or animals.
13