Publicidad
Idiomas disponibles
Idiomas disponibles
ProbJern
Pump has following problems:failure
to producepressure, erratic pressure,
chattering, loss of pressure, low water
voJurne.
Unit fails to start when spray gun
trigger is squeezed.
Detergent faiJsto mix with spray.
Steam functionfaiJs to operate.
Cause
1. Water inlet is blocked.
2. inadequatewater supply.
3. Garden hose is kinked or leaking.
4. Cloggedwater inlet screen.
5. Water supply is over IO0°F (38°C).
6. High pressure hose is blocked or
leaks.
7. Spray tip or nozzle is obstructed.
8. Pump is faulty.
1. Water supply is not turned on.
2. Unit is not turned on.
3. Garden hose is too long.
1. Siphon tube is clogged or cracked.
2. Siphon tube is not fully inserted in
detergent tank.
3. High pressure spray tip installed.
1. Steam function is not turned on.
2. No water in water tank.
3. Siphon hose is cut or leaks.
4. Siphon hose is not fully inserted in
water tank.
5. Trigger is locked.
Correction
1. Clearinlet,
2. Provide adequatewater flow.
3. Straighten garden hose or replace if
leaking.
4. Checkand clean water inlet screen.
5. Provide cooler water supply.
6. Clearblocks in high pressure hose
or replace hose.
7. Cleanspray tip or nozzle.
8. Contact Sears service facility.
1. Turn on water supply.
2. Press the master ON/OFF switch to
the Pressure WasherON position
(-). Reset GFCI.
3. Use only 50 ft. (15.24 m) maximum
garden hose.
1. Cleanor replacesiphon tube.
2. insert siphon tube so that end
contacts bottom of detergent tank.
3. Replacewith low pressure (black)
spray tip.
1. Press the master ON/OFF switch to
the Steam ON position (=).
2. Fill water tank with clean distilled
water.
3. Examine siphon hose and replace if
faulty.
4. insert siphon hose so that end
contacts bottom of water tank.
5. Unlock trigger.
19
Publicidad
