Fein SCT 5-40 Manual De Instrucciones página 12

3 41 01 033 06 8 - Buch Seite 12 Donnerstag, 4. September 2003 3:43 15
EN
Screw in one sample screw as far as the
stop.
Correct the screwing depth.
If the screw is to be screwed in deeper,
screw in the stop collar further. If the
screw is screwed in too deeply,
unscrew the collar stop accordingly.
Example: After being screwed in for the
first time, the screw is still projecting
1.5 mm from the material. Turn in the
stop collar 1.5 turns to reach the correct
screwing depth.
Cleaning and care.
!
Risk of injury
by switching the tool ON unintentionally.
Before cleaning, pull out the mains plug.
Carry out the following once a week, or
more often if the power tool is used more
frequently:
Clean the venting openings.
Blow out the motor space from outside
with dry compressed air.
Maintenance and repairs.
!
Risk of injury
Service, testing and repairs may only be car-
ried out by electrical engineers in conformity
with the regulations valid in the respective
country.
Maintenance and repairs.
We recommend our customer service
department (repair centre), FEIN author-
ised service centres and agencies.
Addresses can be found at the end of
these operating instructions and in the
enclosed safety instructions.
12
SCT 5-40 / SCT 5-40 U / SCT 6-25
Please hand these operating instructions
to the repair centre. An overview of spare
parts can be found at the end of these
operating instructions.
Upon request a repair manual is sent to
the electrical engineers.
Only use original FEIN spare parts.
Spare parts.
The overview of spare parts is at the end
of these operating instructions. Quoting
the parts no. (1), reference no. (2) as well
as the number of spare parts (3) facilitates
the ordering procedure.
Accessories.
Illustrations and reference numbers can be
found at the end of these instructions.
Description of the accessories:
A The bit stop consists of the connecting
collar and stop collar.
B Different inserts,
shaft 1/4" hexagon
(PZ = Pozidriv, PH = Phillips,
TX = Torx, SW = width across flats,
hexagon).
C Bit case
consisting of: 1 holder with spring
washer, magnetic and 9 different
1/4" bits for Phillips and slotted
screws.
D Diamond bit case
consisting of: 1 holder with spring
washer, magnetic and 6 diamond-
coated 1/4" bits for Phillips screws.
E Tek bit case
34 parts, consisting of: 1 holder with
spring washer, magnetic, 20 bits for
Phillips screws sizes 1 – 3 Form H/
Form Z, 10 bits for recess Torx
screws TX 10, 15, 20, 25, 30, 40, and
3 sets of magnetic hexagonal socket
wrenches SW 8, 10, 3/8".