Refrigerator Features; Water Filtration System - Thermador KBULT3651A Manual De Uso Y Cuidado

Turning Refrigerator On and Viewing Set Points
Press and hold POWER (ON/OFF) for 2 seconds.
Viewing the Celsius Temperatures
Press °C SELECT touch pad. The negative sign (-) will light
up. To redisplay degrees Fahrenheit, press °C SELECT again.
NOTE: If the freezer temperature is below zero, the negative sign
next to the freezer display will light up. This is normal.
Adjusting Controls
The set point range for the freezer is -5°F to 5°F (-21°C to
-13°C). The set point range for the refrigerator is 34°F to 46°F
(1°C to 8°C).
Press the refrigerator or freezer PLUS (+) or MINUS (-) key
pad until the desired temperature is reached.
NOTE: Wait at least 24 hours between adjustments. Recheck
the temperatures before other adjustments are made.
CONDITION/REASON:
REFRIGERATOR too cold
Not set correctly for conditions
REFRIGERATOR too warm
High use or room very warm
FREEZER too cold
Not set correctly for conditions
FREEZER too warm/too little
ice
High use or heavy ice use
6
TEMPERATURE
ADJUSTMENT:
REFRIGERATOR Control 1°
higher
REFRIGERATOR Control 1°
lower
FREEZER Control 1° higher
FREEZER Control 1° lower
WATER FILTER Status & Reset
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
The water filter display will help you know when it is time to
change your filter. To change the filter, see the "Water Filtration
System" section.
INDICATOR:
99 percent
10 percent
0 percent or flow decreases
After replacing the water filter, press RESET and hold for
2 seconds to change the water filter display to 99 percent.
REFRIGERATOR
FEATURES
Wat e r F i l t ra t i o n S y s t e m
The Base Grille Water Filter Status Light
The water filter indicator display or light will help you know when
to change your water filter cartridge. The display or light is
located at the top of the refrigerator compartment.
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
A new water filter should display a reading of 99% and will
continue to decrease as the filter life is used. When display reads
10%, it is time to order a replacement filter. It is recommended
that you replace the base grille water filter cartridge when the
water filter indicator light changes to 0% OR when water flow to
your water dispenser or ice maker decreases noticeably. (See
"Changing the Base Grille Filter" later in this section.)
After changing the water filter cartridge, reset the water filter
status light by pressing and holding the RESET for 2 seconds.
The indicator light will change to 99% when the filter indicator is
reset.
STATUS:
New filter installed
Order replacement filter
Replace filter