Publicidad
Idiomas disponibles
Idiomas disponibles
30
TROUBLESHOOTING
TROUBLESHOOTING
Checking
error
messages
If the following message appears on the display, check the foiiowing and take the appropriate corrective action
Water in the washer
drains slowly or not
at all, or the display
shows:
Washer fills with water
slowly or not at all, or
the display shews:
Washer will not turn on
The display shows:
The display shews:
The display shows:
The display shows:
P_sible
Buses
Solutions---
- Drain hose is bent, pinched, or clogged.
• Make sure the drain hose is free of clogs, kk_ks, etc.,
and is not pinched behind or under the washer,
• Water pressure to tap or house is too tow.
- Power cord is not properly plugged in.
- House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
The lid is not dosed properly
. Lid lock switch error
• Water level is too high due to a faulty water
valve,
- Clutch error
• Make sure that the water taps are open fully
Make sure the hoses are not kinked or pinched
Be
careful when moving the washer,
° Ciean the inlet filters, See the Care and Cleaning
section.
• Check another faucet in the house to make sure that
household water pressure is adequate
• Make sure that the plug is plugged securely into a
grounded, %prong, 120_VAC, 60-+_z. outlet
• Reset circuit breaker or replace fuse, Do not increase
fuse capacity, if the problem is a circuit overload, have
it corrected by a qualified electrician,
• Make sure that the lid is closed properly and press the
START/PAUSE button. After starting a cycle, it may
take a few moments before the drum begins to turn or
spin, The washer will not spin unless the lid is locked
(LID LOCK light will turn on}.
• if the lid is closed and locked and the open lid error
message is displayed, call for service,
° If you press the START button while the lid is open, dE
error message will be displayed
• Make sure that the lid is closed properly and press the
START/PAUSE button, The washer will not spin unless
the lid is locked (LID LOCK light witl turn on},
° If the lid is closed and the lid lock error message is
ed, call for service.
- Close the water taps, unpkig the washer, and call for
service.
° Unplug the washer, and call for service,
• Water supply taps are not open fully.
° Water line hoses are kinked, pinched, or
bent.
° Water irfiet filters are clogged,
Publicidad
