TROUBLESHOO[
tNG
3_
Checking
error messages
(conf.)
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
The display shows:
• The washer has detected an out of balance
load.
• If the uE rebalance (see above) is not
successful, this error will be displayed.
° The load is too small,
• Heavy articles are mixed with lighter items.
• The load is out of balance.
• Thermistor error
• The water level sensor is not working
correctly.
• Thermal overload protection circuit in the
motor has been tripped,
If an error message is displayed for
4 minutes, the water in the tub wiii
automatically drain. An alarm will sound 1
minute prior to draining, and 'dr' will appear
on the display. You may restart the washer
at this time. However, once the washer
initiates draining, all functions will be
suspended, and 'dr' will be displayed until
draining is complete.
If the washer detects a load that is too far out of
balance to spin, it will display this code while it is
attempting to rebalance the load, The washer will add
water and try to redistribute the toad automatical!y,
This display is for your information
only, and no action
is required.
• The automatic attempt to rebalance the load was not
successful. The cycle has been paused to allow the
load to be manually adjusted_
• Smal_ loads may need additional items to be added to
al!ow the washer to balance the loads.
o The load may have heavy items loaded with lighter
items, Always try to wash articles of somewhat similar
weight to allow the washer to evenly distribute the
weight of the load for spinning
• Manually redistribute
the load if articles have become
tangled preventing the automatic distribution from
working properly.
• Unplug the washer and call for service.
, Close the water taps, unplug the washer, and call for
service.
o Allow the washer to stand for 30 minutes to allow the
motor to cool; then restart the cycle. Jfthe LE error
code still appears, unplug the washer and call
for service.
• This is normal.