GE WPDH8850 Manual Del Propietário página 20

Installation Instructions
INSTALLING THE WASHER
1. Run some water from the hot and cold faucets to flush
the water linesand remove particles that might clog
the water valve screens.
2. Removethe inlet hoses from the plastic bag.
3. (90° elbow end)
Carefullg connect the inlet
hose marked HOTto the
outside "H" outlet of the
water valve.Tighten bg hand,
then tighten another 2/] turn
with pliers. Carefullg connect
the other inlet hose to the
inside "C" outlet of the water
valve.Tighten bg hand; then
@
tighten another 2/] turn with pliers. Do not crossthreed
or over-tighten these connections.
4. Connect the inlet hose ends to the HOTand COLDwater
faucets tightlg bg hand, then tighten another 2/] turn
with pliers. Turn the water on and check for leaks.
S.
.
Carefullg move the washer to its final location. Gentlg rock
the washer into position. It is important not to damage
the rubber leveling legs when moving gour washer
to its final location. Damaged legs can increase washer
vibration. It mag be helpful to sprag window cleaner on
the floor to help move gour washer into its final position.
NOTE:To reduce vibration, ensure that ell four rubber
leveling legs ere firmly touching the floor. Push end
pull on the beck right end then beck left of your
washer.
NOTE:Do not use the dispenser drawer or door to lift
the washer.
NOTE:If you are installing into a drain pan, you can use
a 24-inch long 2x4 to lever the washer into place.
With the washer in its
final position, place
a level on top of the
washer (if the washer
is installed under a
counter, the washer
should not be able to
rock). Adjust the front
leveling legs up or down to ensure the washer
is resting solidlg. Turn the lock nuts on each leg
up toward the base of the washer and snug with
a wrench.
NOTE: Keep the leg extension et e minimum to prevent
excessive vibration. The farther out the legs ere
extended, the more the wesher will vibrate.
If the floor is not level or is damaged, gou mag have
to extend the rear leveling legs.
2O