Publicidad
INK ROLLER
REPLACEMENT
{f printing is blurry, check if the ink roller is in the correct position.
If printing is blurry
even when the ink roller is in the proper position, replace the roller with our authorized
new ink roller according to the following procedure.
Ink roller: Type EA-741R
WARNING
APPLYING
INK TO WORN
INK ROLLER
OR USE OF UNAPPROVED
INK
ROLLER MAY CAUSE SERIOUS DAMAGE TO PRINTER.
1. Set the power switch to the OFF position.
2. Remove the printer cover by sliding it. (Fig. 1)
3. Move the knob of the ink roller slightly towards you and then lift it up (in the direction
of the arrow). Take care not to catch the ink roller under the case. (Fig. 2)
4. Install the new ink roller and push the knob of the ink roller. Make sure that the ink
roller is securely in place. (Fig. 3)
5. Replace the printer cover.
Note:
When you clean the printer cover, remove the printer cover by sliding it. (Fig. 1)
Then clean the printer cover by using a soft, dry cloth.
Do not use solvents or
a wet cloth.
N
Fig. 1
Fig. 2
Fig. 3
If the print becomes dull after long time usage, clean the printing wheel accordirg
to the following procedures:
1) Install the roll paper and feed it until it comes out of the front of the print mechanisn.
2) Remove the printer cover and the ink roller.
3) Put a small brush (like a tooth brush) lightly to the printing wheel and clean it ky
pressing
:
4) Replace the ink roller and the printer cover.
Publicidad
