Publicidad
Idiomas disponibles
Idiomas disponibles
EXISTING CONSTRUCTION (JOIST/ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
10. Install the previously removed wire housing cover (K)
into the housing (A) and secure using the wire housing
screw (II). Ensure all of the wiring connections are
inside of the housing (A) or under the wire housing
cover (K).
Hardware Used
0
Wire Housing Screw
~
X
1
Proceed to FINAL INSTALLATION INSTRUCTIONS on
page 16.
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. If there is an existing fan in place, remove the existing
fan and ensure that the opening in the ceiling is large
enough for the new fan. Use the template (H) provided
to determine if the existing hole in the ceiling is large
enough for this new fan to be installed. You may be
required to make the hole larger to match the size of
the template (H) provided.
Note: If the existing hole from the previous fan is larger
than the template (H), the hole must be made
smaller to match the template (H) provided.
b. lfthere is not an existing fan in place, choose the
location in the ceiling and cut an opening according
to the size of the template (H). Ensure that one edge
of the opening aligns with the edge of the joist.
2. Insert the housing (A) at an angle through the ceiling
opening and temporarily place the housing (A) above
the existing ceiling.
Note: For access from below installation, you must have
at least 10 in. of clearance between sub floor and
ceiling for the fan's chassis to fit properly.
13
joist
~
.
··
~
···--·-··-::
...
~
UTILITECH'
]
L owes.com
l!l)
- · - :
Publicidad
