Corby Kendal Manual De Instrucciones página 10

INSTALLATION (WITH RESERVED WIRE)
1.
Follow 'WALL MOUNTED'
instructions numbers 1 to 6.
2.
Open
To remove the cover, first
remove the hand piece
and unscrew the 4
screws from the cover.
3.
Unscrew the cable clamp.
6.
Screw the front cover back into place and cover the
screw hole with the screw cover.
1 0
Back of hair dryer holder
Cable clamp
Entry point
4.
Drill a hole where the
cable needs to enter the
cable entry point.
Reserved wire
5.
Pull the reserved wire
through the entry hole
and connect to the
terminal.
Ensure there is enough
cable to allow the base
unit to be un-hooked
and unclipped from the
rear should access to the
connections be required
in the future.
Existing
cable
Terminal