Descargar Imprimir esta página

Futurelight PHW-710 Pro-Head-Wash Manual Del Usuario página 36

Publicidad

Idiomas disponibles

Idiomas disponibles

Caution: Projectors may cause severe injuries when crashing down! If you have doubts concerning the
safety of a possible installation, do NOT install the projector!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the projector's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Follow the instructions mentioned at the bottom of the base.
the structure (truss) to which you are attaching the fixtures is secure.
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Before taking into operation for the first time, the installation has to be approved by an expert!
DANGER OF FIRE!
Use 2 appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly! Ensure that
DANGER TO LIFE!
CAUTION!
The Moving-Head can be placed directly on
the stage floor or rigged in any orientation on a
truss without altering its operation characte-
ristics (see the drawing).
The fixture's base enables to be mounted in
two ways.
For overhead use (mounting height >100 cm),
always install an appropriate safety bond.
You must only use safety bonds complying
with DIN 56927, quick links complying with DIN
56926, shackles complying with DIN EN 1677-
1 and BGV C1 carbines. The safety bonds,
quick links, shackles and the carbines must be
sufficiently dimensioned and used correctly in
accordance with the latest industrial safety
regulations (e. g. BGV C1, BGI 810-3).
36/103
00025949.DOC, Version 1.4

Publicidad

loading