Panasonic CW-606TU Instrucciones De Funcionamiento página 5

AIR CONDITIONER OPERATION
1. Power Supply
Set the main control switch to the OFF position; confirm that the
power supply cord is connected to a proper AC outlet.
< 115V, 60Hz >
2. Open the cover
5. Mode Switch
3. Main Control Switch
Set MAIN CONTROL SWITCH
to desired position
:^h,gh
$ OFF
Stops all operations.
* HIGH LOW FAN
^ Fan only operation without
! cooling at low fan speed.
HIGH FAN
° Fan on'y °Peration w|thout
f
cooling at high fan speed.
' V
J
s (fan only operation
recirculates filtered room air).
***HIGH
lowcool
j
(/ /]
s Cooling operation at low fan
J
1 speed.
HIGH COOL
(r
-Ni x> Cooling operation at high fan
'V-speed.
Note: For fan only operation, operation Mode Switch must
. be in REGULAR Position.
4. Temp Control
Switch
TEMP
CONTROL
• For a room that is too
warm, set the control
switch to clockwise
direction.
• If the room is too cool,
set the control switch
to anti-clockwise.
• Note
Usually 6-7 is
recommended setting
position.
V
J
• REGULAR POSITION:
The temp, control automatically
controls cooling, but the fan runs
continuously whenever the air con¬
ditioner is in operation.
• ECONOMY POSITION:
The temp, control automatically
controls cooling, but when the room
temperature reaches the temp, con¬
trol preset point, both the fan and
compressor turn off. When the temp,
control requires the cooling opera¬
tion to start again, both the fan and
compressor turn back on together.
'Note
If only the fan operation is desired,
set the operation mode switch to
"REGULAR".
The fan will not run with the switch
setting combination at "FAN" of main
control switch and "ECONOMY" of
operation mode switch.
* Caution:
If the main control switch is turned off or changed to a fan
setting from a cooling operation setting, WAIT at least 3
minutes before resetting to a cooling operation.