Skil PWRCORE 20 Manual Del Propietário página 20

Limbing
Limbing is removing branches from a fallen tree.
When limbing, leave larger limbs to support
the log off the ground. Use the pruning saw to
remove the small limbs in one cut as illustrated
in Fig. 14.
WARNING
limbing operation. Be extremely cautious and
avoid contacting the log or other limbs with the
tip of the guide bar.
WARNING
kickback guard must not be lifted during
operation. Never use it to cut the support
branches under tension.
For better performance, do not cut a branch with a diameter greater than 5-7/8 in.
NOTICE
(15 cm).
Pruning (Fig . 15)
Pruning is trimming limbs from a live tree.
Work slowly, keeping your hand on the
•
pruning saw with a firm grip. Always make
sure your footing is secure and your weight is
distributed evenly on both feet.
Do not cut from a ladder, this is extremely
•
dangerous. Leave this operation for
professionals.
Do not cut above shoulder height as a saw
•
held higher is difficult to control against
kickback.
When pruning trees, be aware of the risk of
•
stripping the bark from the main limb or trunk
when the cut is made next to the main limb or trunk.
WARNING
For better performance, do not cut a branch with a diameter greater than 5-7/8 in.
NOTICE
(15 cm).
Bucking a Log
Bucking is cutting a log into lengths. It is important to make sure your footing is firm and your
weight is evenly distributed on both feet. The log should be supported along its entire length.
Follow these simple directions for easy cutting.
WARNING
20
There is an extreme danger
of kickback during the
The saw is not suitable for
bottom-up cutting as its
If the limbs to be pruned are above shoulder height, hire a professional to
perform pruning. Failure to do so could result in serious personal injury.
Keep the cutting area clear. Make sure that no objects can contact the guide
bar nose and chain during cutting. This can cause kickback.
Fig. 14
Limb out
Fig. 15
2
1
First cut to reduce load
Final Cut