Facom CL3.C10SD Manual Original página 23

Variable Speed Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (A). To turn the tool off, release the trigger switch. Your tool is equipped with a brake. The anvil
will stop when the trigger switch is fully released. The variable speed switch enables you to select the best speed for a particular application.
The more you squeeze the trigger, the faster the tool will operate. For maximum tool life, use variable speed only for starting holes or
fasteners.
NOTE: Continuous use in variable speed range is not recommended. It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
A forward/reverse control button (B) determines the direction of the tool and also serves as a lock off button. To select forward rotation,
release the trigger switch and depress the forward/reverse control button on the right side of the tool. To select reverse, depress the
forward/reverse control button on the left side of the tool. The centre position of the control button locks the tool in the OFF position. When
changing the position of the control button, be sure the trigger is released.
NOTE: The fi rst time the tool is run after changing the direction of rotation, you may hear a click on start up. This is normal and does not
indicate a problem.
Proper Hand Position (Fig. 4)
WARNING: To reduce the risk of serious personel injury, ALWAYS use proper hand
position as shown.
WARNING: To reduce the risk of serious personel injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the main handle (G).
Worklight (Fig. 5)
There is a worklight (E) located above the trigger switch (A). The
worklight is activated when the trigger switch is depressed, and will
automatically turn off after the trigger switch is released. If the trigger
switch remains deperessed, the worklight will remain on.
NOTE: The worklight is for lighting the immediate work surface and is
not intended to be used as a fl ashlight.
Anvil with Hog Ring (Fig. 6)
WARNING: Use only impact sockets. Non-impact sockets may break
and cause a hazardous condition. Inspect sock et prior to use to ensure that it con tains no cracks.
Place the forward/reverse button (B) in the locked off (centre) position or remove battery pack
before changing accessories.
To install a socket on the hog ring anvil, fi rmly push socket onto the anvil (F). The hog ring
(K) compresses to allow the socket to slide on. After the socket is installed, the hog ring applies
pressure to help provide socket retention.
To remove a socket, grasp the socket and fi rmly pull it off.
CAUTION: Inspect anvils and hog rings prior to use. Missing or damaged items should be
replaced before use.
Model Square drive
in
CL3.C10JD 3/8
CL3.C10RD 1/4
CL3.C10SD 1/2
NU-CL3.C10JD CL3.C10RD CL3.C10SD_1015.indd 23
SPECIFICATIONS
Impact rate Breakaway
torque
Pressure dB(A)
bpm N.m
1900 200 88
1900 95 89
1900 270 88
4
5
E
Noise level
Power dB(A)
k* k*
3 99 3
3 101 3
3 99 3
23
6
F
K
Vibrations level
m/s
2
Pressure dB(C)
k* k**
111 3 11.1 3,1
113 3 13 2,8
111 3 11.1 3,1
2/29/2016 10:09:09 AM
G