GE AEE08 Manual Del Propietario Y Instrucciones De Instalación página 11

Window Installation Instructions
r_ INSTALL THE CASE IN THE WINDOW
r_ open the window and mark the centerline of the
window stool.
r_ Carefully place the case on the window stool and
align the center murk on the bottom front with the
centerline of the stool.
r_ Pull the window down behind the top mounting rail.
NOTE: Do not shut the window so tightly that movement
of the accordion panels is restricted.
[] Select the position that will place the sill supports
near the outermost point on the sill. Placethe short
side of the sill supports, on the case bottom, toward
the window. Attach the sill supports to the case track
hole in relation to the selected position using 2 Type
B screws in each support.
A CAUTION: Do not i nstall this air
conditioner in e window if the bolts do not contact
the window sill.
I I
\
Longsideof
sillsupports
OUTSIDE
[] Adjust the bolt and the nut in each support so that
the case is installed with a slight tilt to the outside.
Use a level; no more than 1/2 bubble will be the
correct case slant to the outside.
A CAUTION:
_f thesill support bolts do
notcontoct thewindow sill orif you hoveo window
without o sill you must order occessory k it RAK87 to
properly i nstall this oir conditioner. Coll 800.626.2002
orvisit GEApplionces.com.
171INSTALL THE CASE IN THE WINDOW
(CONT.)
r_ Secure the case to
the window stool
by using ] Type D
screws.
Sill
support
Pull the accordion
panels to each window
sash track. Attach them
on each side to the
window sash and the
window stool using 4
Type C screws.
B1
B]
SECURE THE CASE IN THE WINDOW
AND INSTALL THE FOAM TOP
WINDOW GASKET
CAUTION:
To prevent broken glass Vinyl
or damage to windows,
on vinyl or other similarly
constructed windows,
attach the support bracket
to the window side jam.
Attach the window
locking brackets (on one
each side) with Type C
screws.
Cut the foam top window gasket to the window
width.
Stuff the foam
between the glass
and the window
to prevent air
and insects from
getting into the
room.
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal.
11