GE AEE08 Manual Del Propietario Y Instrucciones De Instalación página 7

I stall ti
I structi ns
Air Conditio r
BEFORE YOU BEGIN
Read these instructions completely and carefully.
. IMPORTANT
- Save these instructions
for local inspector's use.
. IMPORTANT - Observe all
governing
codes and ordinances
, Note to Installer- Be sure to leave these
instructions with the Consumer.
, Note to Consumer - Keep these instructions for
future reference.
, Skill level - Installation of this appliance requires
basic mechanical skills.
, Completion time - Approximately 1 hour
. We recommend that two people install this
product.
. Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
You MUST use all supplied ports and use proper
installation procedures as described in these
instructions, and any separate kit instructions,
when installing this air conditioner.
ELECTRICAL REQUIREMENTS
Some models require a 115/120-volt a.c., 60 Hz
grounded outlet protected with a 15-amp time
delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the
possibility of electric shock hazard. If the wall outlet you
plan to use is only a 2-prong outlet, it isyour responsibility
to hove it replaced with a properly grounded 3-prong
wall outlet.
(_ Some models require 230/208-volt o.c.,
protected with a time delay fuse or circuit
breaker. These models should be installed
on their own single branch circuit for best
performance and to prevent overloading house
or apartment wiring circuits, which could cause
a possible fire hazard from overheating wires.
tkCAUTION:
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
Do not change the plug on the power cord of this
air conditioner.
Aluminum house wiring may present special
problems-consult a qualified electrician.
If the sill support bolts do not contact the window
sill, or if you have a window without a sill, you
must order accessory kit RAK87 to properly install
this air conditioner. Call 800.626.2002 or visit
GEAppliances.com.
TOOLS YOU WILL NEED
Phillips-head screwdriver
Adjustable wrench Flat-blade screwdriver
Pencil Ruler or tape measure
Level Scissors or knife
Power cord includes a current interrupter device. A
test and reset button is provided on the plug case.
The device should be tested on o periodic basis by
first pressing the TEST button and then the RESET
button. If the TEST button does not trip or if the RESET
button will not stay engaged, discontinue use of the air
conditioner and contact a qualified service technician.