Operating Mode - Cardin Elettronica DKS 250 Manual Del Usuario

4. Memorising codes from a remote position
If you have not already carried out the "Memorising the programming function access code for remote memo-
risation from the keyboard ", do so now (ref. 2, pag. 14)
Attention! Memorising is only possible if jumper "J2" has been inserted
If the "Memorising the programming function access code" procedure has been carried out:
4a Type the function access code into the keyboard
and press confirm "
4b The keyboard will emit a beep and the red and green LEDS
will light up (the green LED will then switch off)
The function is active!
4c
Type the desired numerical code into the keyboard
(max 6 digits e.g. 1-2-3-4-5-6) and press confirm "
4d The keyboard will emit a beep for two seconds
and the green LED will light up
The code has been accepted and memorised
4e
Within 13 seconds of confirming the code press
one or more functions A-B-C-D in sequence (e.g. A-C)
4f
Press confirm "
The functions have been assigned (e.g.. A-C)
5. Cancelling a single code
5a Remove jumper "J2" from the interface
5b Press and release button "P1" on the interface

OPERATING MODE

*
"
*
" and the keyboard will emit a beep
16
*
*
"
*
9
D
4
8
*
7
0
*
ON
3
B
2
6
C
1
9
D
4
8
7
0
*
ON
3
B
2
6
1 C
A
3
B
2
6
1 C
5
9 D
4
8
9
D
4
8
7
0
*